Ross DED-8420, User Manual, Page: 20 / 36

3-4
•
User Controls DED-8420 User Manual (Iss. 01)
DIP SW8 — DashBoard Enable
SW8 is used to enable remote control of the DED-8420 from DashBoard.
Set SW8 as follows:
•
ON — Select this setting to disable remote control from DashBoard. The
parameters and settings cannot be changed via DashBoard and must be changed
using the card-edge controls. You can still monitor the status of the card using
DashBoard.
•
OFF — Select this setting to control the DED-8420 from DashBoard or the card-
edge. This is the default setting.
LEDs
The front-edge of the card features LEDs that display the status of the input signals. ( Figure 6 )
Figure 6. Card-edge User Controls
As selections are made in the menus, the LEDs display the status of the input signals. Descriptions
are provided in
Table 3 .
Table 3. Selection and Status LED Descriptions
LED Color Display and Description
AES 1
Green
When lit and green, this LED indicates that there is a valid
AES/EBU input signal on AES1 IN.
DOLBY 1
Yellow When lit, this LED indicates a Dolby signal is detected on AES1 IN.
ERROR 1
Red
When lit, this LED indicates that the AES/EBU input signal is
invalid on AES1 IN.
AES 2
Green
When lit and green, this LED indicates that there is a valid
AES/EBU input signal on AES2 IN.