Ross CrossOver 6, Installation Manual, Page: 14 / 24

Installing the hyperSTATION Upgrade
2-4 hyperSTATION Upgrade Installation Guide
Carefully pull each SBus card from its connector on the motherboard.
Set the SBus card(s) and any screws aside on a clean, anti-static surface. You will
replace all SBus cards removed from the computer after you install the
hyperSTATION motherboard.
Note: AFX Bus cards must be removed from SPARCstation 5 computers where fitted
and cannot be reused with the new hyperSTATION motherboard. SBUS graphics
options must be used
3. Disconnect the following cables from their connectors on the motherboard:
• Floppy drive cable (Optional)
• CD ROM audio cable (on SPARCstation 5 only)
• Internal SCSI cable (Hard disk / CDROM)
• Power supply cable
• LED/speaker cable
The number, type, and location of these connectors vary depending on the system you
have. Please refer to the hardware manual provided with your system.
SBus Card
SBus Card Connector
on Motherboard
Card Retainer Clips
Power Supply
Floppy
LED/speaker cable
Internal SCSI
connector
cable connector
cable connector
cable connector
Back panel
Audio Cable on SPARCstation 5