Ross CrossOver 6, Installation Manual, Page: 12 / 24

Installing the hyperSTATION Upgrade
2-2 hyperSTATION Upgrade Installation Guide
2. Back up the system files and data to tape.
3. Notify any users who share the system that the system will be shut down.
4. Halt the system with the appropriate system commands. Refer to the manual provided
with your system for information on how to do this.
A “system halted” message appears, followed by the boot monitor prompt.
5. Turn off power to all external drives.
6. Turn off power to the computer.
7. Turn off power to the monitor and any other peripheral devices.
8. Disconnect the monitor cable from the connector on the back panel of the computer.
9. Disconnect all other peripheral device cables from their connectors on the computer.
Important:
Unplug the power cable from the computer before you proceed.
Serious damage could occur to the motherboard if you do not unplug the
power cable prior to doing the motherboard installation!
Task 2: Open the computer
To remove the cover from the computer:
1. Use a #2 Phillips screwdriver to loosen the captive screws that hold the cover to the
back panel. The number and positions of the screws vary. Refer to the hardware
manual provided with your computer for this information.
2. Use the Phillips screwdriver to press the retainer clip while you loosen the cover from
the back panel with your other hand.
Captive Screws