Ross ADA-8405-C, User Manual

Page: 22 / 36

3–2 • User Controls ADA-8405-C User Manual (Iss. 02)
Card Overview
This section provides a general overview of the ADA-8405-C DIP Switches. Refer to Figure 3.1
for DIP Switch location.
Figure 3.1 ADA-8405-C — Components
SW1 — Remote Control
Use SW1 to disable remote control of the ADA-8405-C from DashBoard.
Set SW1 as follows:
• ON — Select this setting to disable remote control from DashBoard. The parameters and
settings cannot be changed via DashBoard and must be changed using the card-edge
controls. You can still monitor the status of the card using DashBoard.
• OFF — Select this setting to control the ADA-8405-C exclusively from DashBoard. The
card-edge controls are ignored. This is the default setting.
SW2 — DIP Switch Control
Use SW2 to determine whether DIP Switch settings are applied or ignored.
Set SW2 as follows:
• ON — DIP Switch status is reported in DashBoard, and DIP Switch settings are applied.
Any parameter adjustments made in DashBoard are ignored.
• OFF — DIP Switch status is reported in DashBoard, however DIP Switch settings are
ignored. Parameter adjustments made in DashBoard are applied. This is the default
setting.
SW3, SW4 — Output Mode Selection
SW3 and SW4 are used in conjunction to set the output mode of the ADA-8405-C. Refer to the
section “ Setting the Output Mode ” on page 3-3 for details.
SW5
This DIP Switch is not implemented.
SW6 - SW10 — Gain Control
These switches are used in conjunction to apply a specific Gain value (dB). Refer to the section
“
Specifying the Gain ” on page 3-3 for details.
DIP SW1-10