Figure 3. Connector Wiring for ADA-7802 Inputs and Outputs
1. Insert an audio wire into the designated polarity slot on the connector.
2. Use a tweaker screwdriver to tighten the corresponding screw on the underside of
the connector.
3. Repeat steps 1 and 2 for each wire on each connector.
4. Secure the cable to the connector with a tie wrap.
5. Once the cables have been wired to the connectors, install the connectors to the
sockets on the RossGear frame so that the slotted tongue fits in the grooves on the
frame’s mating connector.
Figure 4. ADA-7802 Cabling Designations for Rossgear 7812C and 7814C Series Frames
Note
When using the ADA-7802 in
MONO
mode, use the same outputs as you
would when operating in
STEREO
mode. The outer labeling on the
frame diagram above refers to the cabling requirements for an ADA-
7801, which is a mono amplifier.
2-4
•
Installation and Setup
ADA-7802 User Manual (Iss. 09A)
