PAGE 9
Rositek Technologies
www.rositek.com
© 2021 Rositek
All rights reserved
Email: [email protected]
USER GUIDE AND TROUBLESHOOTING
Pressing
with PPM4
2 -IN -1 Presser
1. Insert the included power cord into the power cord socket and then plug the
other end into an electrical outlet.
2. Turn the knob clockwise until it is firmly closed to seal the release valve.
3. Flip the ON / OFF switch to turn the press on. The PID temp controller and
the power switch both become lit.
4. Press the PID control panels to set the desired temperature (About how to
set the temperature, please refer to
Page 11
)
.
5. Wait until the platens heat up to the desired temperature.
6. Align the side without two corners on the bottom with the bottom plate, push
it inward to the end.The plate and the mold are exactly flush.
Pay attention to
the directions of the bottom of the mold’s base.
7. Pump the jack handle until you can no longer pressure applied.
8. Turn the valve knob counterclockwise to release the press and lower the
bottom platen.
9. Remove the press mold using heat resistant gloves or tools.
10.Take out the brick. If get stuck, you can use a small rubber hammer or
wooden stick to hit the two corners on the bottom of the mold.
11. Turn the machine off by flipping ON / OFF switch when done pressing.
12.Unplug and then disconnect the power cord from the press.
13. Wait until the press cools down completely to clean and store it.
Step for
Creating Birck
Two corners
OPERATING INSTRUCTIONS (continued)