User Manual: Wireless Access Point
6
/
16
2)
Configure input
WAP-348X has 4 toggle switches on the front panel. These are used to select
operation model.
Bit of switch
Description
BOOT_0
Use for factory debug. Keep it to “ON” position.
BOOT_1
Use for factory debug. Keep it to “ON” position.
TEST_SEL
Test mode selection. Keep it to “ON” position for normal work
mode.
LOGIC_SEL
Selection for output signal logic level.
OFF(0): Output high level when vehicle detected (OC);
ON(1): Output low level when vehicle detected.
Normally, for customers the only available selection is LOGIC_SEL.
3)
Reset
Reserved.
4)
USB
The USB port is mainly used for purpose of maintenance and debug, but also can be
used as a date transmission interface.
Note that this USB port is a virtual serial port with baud rate 115200bps, 8 digit bits
，
1-digit stop bit and no parity bit.
5)
ON/OFF
Power ON/OFF of WAP-348X.
6)
Work indication
Indication LED
Description
RUN LED
Indicating WAP-348X communicate status. Once WAP-348X
receives wireless signal, this light flashes.
SYS LED
Indicating WAP-348X running status. Flashing once per
second means device work normally. If it stop flashing, the
device out of run.
GSM LED
Indicating the working state of GPRS network.
Rapid flashing: Network abnormal or invalid SIM card
detected.
Slow flashing: Work normally.
Note: This feature is only available to WAP-348X with GPRS
function.
