Popcorn Maker
RHPM-14001
User Manual
4
NOTE :
Handle the stirring rod with care to avoid bending the stirring rod.
DO NOT
pull on the ends of the rod as
this will begin to warp the shape of the stirring rod.
NOTE :
After prolonged use, the nonstick finish may discolor. This will not affect the performance of the popcorn
popper. To remove the discoloration use a soft cloth saturated with lemon juice or vinegar and rub over the finish.
Wipe with a clean damp cloth and dry.
NOTE
:
DO NOT
place the stirring rod or base in the dishwasher.
WARNING
:
DO NOT
immerse main unit, cord or plug into water or any other liquids.
DO NOT
allow any liquid
to accumulate on the popping surface as it will enter the base of the unit under the center knob and damage the
popcorn popper.
CLEANING AND MAINTENANCE
1. Unplug the unit and allow to cool completely before cleaning.
2. Wash the cover/serving bowl and bowl cap in hot soapy water. Rinse and dry.
DO NOT
use scouring pads
or abrasive powder on the cover as these can scratch the plastic. The cover/serving bowl and bowl cap are
dishwasher safe, however, it is recommended to hand wash these parts to prolong the life of these parts.
3. Remove the stirring rod from the base by turning the center knob counter clockwise and lifting up the stirring rod
near the center of the rod. Wash the stirring rod and center knob in hot soapy water. Rinse and dry thoroughly.
5. Place the stirring rod on the center post as shown in
fig. 2
. Screw the center knob in a clockwise direction until
the center knob can turn the stirring rod.
6. The base can nest inside the cover/serving bowl for
compact storage.
4. Clean the non-stick surface of the base with a damp soapy cloth, sponge or nylon scouring pad that is safe for
non-stick surfaces.
DO NOT
use abrasive scouring pads or powders.
NOTE :
After two batches the unit must cool down completely for at least 15 minutes.
MAKING MORE
If you plan to make more popcorn immediately, transfer the cooked popcorn to another serving bowl. Repeat above
steps.
