2 ports Parallel PCI card
RC304 User Manual
3
Overview
This PCI card is a dual 1284 parallel port controller with PCI bus interface and supports the existing
contronics printer interface as well as PS2, EPP & ECP modes and uses an all-in-one solution from
NeMos Technology, which provides superior performance and unmatched data transfer rates. The
most advanced feature is it uses of a single interrupt, which is set automatically by the host system
and share among all on-board I/O ports.
Features
y
Chipset: NetMos Nm 9715
y
Data Transfer Rate: 1.5Mbytes/s(parallel port)
y
Bus: 32bit, 33MHz.
y
Low power: Single 5V operation
y
High speed transfer, Dual parallel port
y
Multi-mode compatible controller (SPP, PS2, EPP &ECP)
y
16Byte FIFO (parallel)
y
Software programmable mode selects
y
Supports Window98, Window95, Window2000 & Window NT 4.0
Installing the PCI I/O controller card into your computer
1.
Turn off your computer and all external devices connect it.
2.
Disconnect your computer from the power sources.
3.
Open the computer case. Refer to your computer user manual for more details.
4.
Find an available PCI slot and remove the slot bracket. Save the bracket screw for later use.
5.
Align the PCI I/O controller horizontally with respect to the PCI slot and insert it into the slot firmly
and evenly. Take care not to force it into the slot. Once you have properly positioned the PCI I/O
controller card into the slot, fasten it to the computer case with the bracket screw you have saved.
6.
Close the computer case. Make sure to reconnect all the external devices power cords to your
computer.
