Operation and maintenance manual
Hoof trimming chute operation manual
- 17 von 22 -
Rev.: 01/2022
– We reserve the right to make technical modifications
12)
Fixing a front foot:
Attention! Always work on a front foot only when the
rear foot is secured on this side!
Place the front foot strap (4) between the claw and the
dewclaw.
Swing the front foot holder in until the foot is between the
two plastic winding bodies. Hook in the small bolt of the foot
belt between the plastic winding bodies and wind up the
foot electrically ((17) black button). Do not overwind the
animal's foot - risk of injury to the animal!
Swing out the front foot holder (11) until the claw is outside
the main frame and thus easily accessible.
Perform hoof care
Swing the foot holder back into the frame and then lower
the leg. This gives the animal a better balance.
Press the green button (17) to release and remove the front
foot strap (4). Swing out the foot holder completely to the
front.
13) After the claw care, loosen all fasteners and securing
elements, the head catch at the end!
14) Open the head catch using the green button on the control
panel (3).
15) Disc grinders may only be used with protection!
16) It is only allowed to put the disc grinder in the grinder holder
on the service arm (19) after the wheel has come to a
complete standstill!
17) When the hoof trimming chute is not in operation, the
emergency stop switch (red) at the head catch control (3) must
be pressed!
All work has to be done sideways, never bend under the body, in front of or behind the
feet of the animal!
