Page 12
Rosen Aviation Displays
Adjusting the Rotation Stop:
The rotation stop may be adjusted to any position from 135
degrees to 180 degrees from stowed. It may be necessary to
adjust the rotation stop such that the display does not open
far enough to make contact with an obstruction.
There are two 6-32 socket head cap screws that need to be
loosened to adjust the rotation stop; one at each end of the
hinge (see photo below). Open the Fold Down to its fully-
opened position (or as far as possible per obstruction), loosen
the two 6-32 socket head cap screws, position the Fold Down
to the desired rotation-stop location and retighten the 6-32
screws (torque to approximately 9 inch/lbs).
Note
: Use a 7/64” Hex Key to loosen and tighten the 6-32
socket head cap screws.
Installation Guidelines
