Parts
35 Congress Street, Salem, MA 01970
Tel# 1- 800 631-9707 Fax# 1-800-560-2890
e-mail:[email protected]
Note: Each graphic should already have
predrilled holes for snap rivets.
Step 1
Insert snap rivets into each predrilled hole.
Snap together. Fig. 1.
Step 2
Slide graphic into aluminum rails (top and
bottom). Rails will conceal snap rivets.
Fig. 2.
Step 3
Insert metal clips into channel of top
aluminum rail. Fig. 3. Slide into place.
Step 4
Insert V clip through hole in metal clips.
Fig. 4. Hang V clip from ceiling grid.
Note: Repeat steps 1-4 for each of your
graphics. Be sure to hang graphics close
enough together so they can be joined.
Step 5
Insert end caps onto rails. Fig. 5.
Note: If you are using multiple panels,
do not insert end caps. Jump to Step 6
on next page.
AdvanceTrak™
Instructions for assembly
Incept-4.8.03
The AdvanceTrak™ is a trademark of Rose Displays, Ltd. Neither the
manufacturer nor any sales agent may be held liable for injury, loss or
damage resulting from the use of these products.
Part #03INSAdvanceTrak
Instruction Sheet
Aluminum Rail
V clip
Metal Clip
Figure 5
Figure 3
Figure 4
Figure 2
Figure 1
End Cap
Snap Rivets
12AR300
Page 1 of 2
