10
6. Turn off the device:
After completing the treatment session, the device will
automatically shut off and all indicator lights will be
off. Power off the device physically by sliding the
power switch downwards (towards “OFF”). Unplug the
unit from its power source.
5. Place sound head on treatment area and begin
treatment:
Move the sound head in a slow, flat, circular motion
over the skin surface of the treatment area. Apply the
sound head evenly (in time) over the treatment area
(see page 11 for
Load Detection System Caution
).
7. Clean the device after every use:
With device turned off, clean the ultrasound head /
probe with a wet towel or soft tissue. Do not immerse
the device in water. Always store device in its
protective case at room temperature in a dry location.
3. Set ultrasound intensity:
Press the “MODE” button to select the modulation duty
cycle. The mode button has three levels, Low (L) - 5%,
Medium (M) - 50% and High (H) - 100%, each level
corresponds to a LED light indicator.
4. Set treatment time:
Press the "TIME" button to cycle through the treatment
time (5, 10 and 15 minutes), as shown by the “TIME”
indicators. When the time is chosen, the system will
start working. During working time, the user can press
the "TIME" button to adjust the treatment time.
