5
Cleaning Cautions:
1.
Do not immerse the unit in water. It may damage the unit.
2.
Disconnect the unit from the electrical outlet before cleaning.
3.
Clean all necessary parts after each use as instructed in this guidebook.
Operating Your Nebulizer
NOTE:
Prior to initial operation, the nebulizer should be thoroughly cleaned.
1.
Place your Roscoe Medical Compressor Nebulizer on a flat and stable
surface. Be sure that you can easily reach the controls
when you are seated.
2.
Open the clear cover and remove the inside accessories.
Important:
Prior to initial operation, the nebulizer should
be thoroughly cleaned referring to the “Cleaning
Procedures” in this guidebook.
3.
Gently twist the top part of the nebulizer counter-
clockwise to disassemble the nebulizer, Fig A.
4.
Fill the bottom section of the nebulizer with the
medication prescribed by your physician. Be sure that the
cone is put inside the bottom section (the stem inside the
medicine cup inserts into the tube of the cone), Fig F.
5.
Gently twist the top part clockwise to and fill medication
re-assemble the nebulizer. Be sure the two sections fit
securely.
6.
Attach one end of air tube to the base of the nebulizer,
Fig G. Attach the opposite end of the tubing to the tube
connector on the front of the compressor.
7.
NOTE: The nebulizer that is provided with your kit is
operable at up to a 45
°
angle.
Attach the angled mouthpiece or optional mask to the
top section of nebulizer, Fig H.
If using the optional tee adapter set (Fig. H):
(a.) Attach the tee adapter to the top of the nebulizer.
(b.) Connect one end of the tee adapter to the straight
mouthpiece and the other end to the extension tube.
NOTE: The tee adapter is not needed when using a
mask.