Rosco Vision SAFE-T-SCOPE 360, Installation Manual And User'S Manual

Page: 5 / 29

5
Features
•
Nine different viewing configurations (see Page Display22)
•
Customizable Automatic Triggering Options
o
System can be set to display a particular viewing configuration when a particular trigger is received.
See “Triggering” section on Page 21
•
Manual Operation
o
Power/channel button harness included
o
Manually activate system via power button
o
Cycle through nine viewing configurations via channel button
•
Video Output Options (Discussed in detail in Video Harness Detail section on Page 9)
o
CVBS: Main output, only active when system is triggered
o
CVBS-RV: Secondary output, always on, useful for recording
Hardware
Cameras (STSC360)
•
Never tamper with camera housings. Camera housings are sealed to prevent moisture and dust intrusion.
•
All four included cameras are identical and can serve as front, rear, or side cameras.
ECU (STSK360ECU)
•
NEVER adjust DIP switches labeled “SW” on rear of ECU.
•
ECU is EMI shielded – DO NOT tamper with housing .
•
3.5 mm IR Port is NOT USED.
•
DO NOT remove rubber gasket from Calibration port unless performing calibration ( See page 12)
Cable Harnesses (STSK360PHAR/VHAR)
•
Minimum bend radius for all cables is two inches (2”).
•
Loom all extension harnesses, especially those for the front camera.
•
For detailed information on Power Harness (STSK360PHAR) see “Power Harness Detail” section, Page 11.
•
For detailed informati on on Video Harness (STSK360VHAR) see “Video Harness Detail” section, Page 9.