- 5 -
UNPACKING
Carefully remove the machine from the box. Your Rosco Vapour Plus will arrive with the bottle holder
detached from the unit. To attach, line up the keyhole openings on the bottle holder with the mounting
hardware on the right side of the machine and push down to secure. Note: 230 volt machines are shipped
with bare leads at the end of the power cord. A proper electrical connector must be attached based on the
local power requirements. Ensure that no tape or packing materials are stuck to the machine. Stray
packing materials that remain attached to high temperature areas of the machine could melt or burn
during operation. In particular, ensure that the area around the nozzle is free of any materials or debris.
CONTROLS
Multi-Link Socket
3-Pin XLR socket that
allows for multiple machines
to be daisy chained together
and controlled from a single
Remote Control Panel.
Main Power Switch
Turns unit on or off by
controlling the flow of
power to the unit.
Air-Input /
Purge Connection
This is a push-to-connect
inlet that accepts ¼”OD
tubing and allows
compressed air to blow
through the heat
exchanger for cleaning
and maintenance.
Ready Indicator
A green indicator light
that illuminates when the
minimum temperature for
producing fog has been
achieved. Note: All indicator
lights will switch off if
Standby mode is engaged.
Heat Indicator
A red indicator light that illuminates
when machine is heating in order to
achieve optimal temperature for
producing fog.
Removable Remote
DMX-OUT
Remote Thumb Screws
Loosen to remove
Power Cable
DMX-IN
DMX Panel & Display
“Down” Button
Press to decrease the
value of the DMX
address. Press and
hold for faster
decrementing speed.
“Set” Button
Press to store
the DMX address
shown on
the display.
“Up” Button
Press to increase
the value of the DMX
address. Press
and hold for faster
incrementing speed.
Main Fuse
Fluid Container
in Bottle Cradle
