1-40
Chapter 1: Product introduction
•
System power LED (2-pin PLED)
This 2-pin connector is for the system power LED. Connect the chassis power
LED cable to this connector. The system power LED lights up when you turn on
the system power, and blinks when the system is in sleep mode.
•
Hard disk drive activity LED (2-pin IDE_LED)
This 2-pin connector is for the HDD Activity LED. Connect the HDD Activity LED
cable to this connector. The IDE LED lights up or flashes when data is read
from or written to the HDD.
•
ATX power button/soft-off button (2-pin PWRSW)
This connector is for the system power button. Pressing the power button turns
the system on or puts the system in sleep or soft-off mode depending on the
BIOS settings. Pressing the power switch for more than four seconds while the
system is ON turns the system OFF.
•
Reset button (2-pin RESET)
This 2-pin connector is for the chassis-mounted reset button for system reboot
without turning off the system power.
15. System panel connector (10-1 pin F_PANEL)
This connector supports several chassis-mounted functions.
iQ965-IGM
System Panel Connector
*
Requires an ATX power supply
PLED-
PWR
RESET
GND
Ground
Reset
PLED+
IDELED-
IDELED
PLED PWRSW
F_PANEL
