Ropox Slimline Electric 40-15601, User Manual

Page: 30 / 35

©
ROPOX 2017
29
Service information
Troubleshooting
Reset: Press and hold the UP (
▲
) and DOWN (
▼
) buttons at the same time. Keep the buttons
depressed for approx. 10 seconds. Now move the frame to bottom position for resetting.
Problem Solution
The washbasin does not move
up or down when pressing the
hand control. Check if:
·
230 V is connected, and if the power is on.
·
The engine is connected to the control box.
·
The control is connected to the control box.
·
The engine is overloaded. (NOTE: For every 2 minutes
of use, it needs 18 minutes of rest).
Hand control is defect. Check if:
·
The washbasin can be height adjusted by means of
another control.
When pressing the UP and
DOWN buttons, only ”click”
sounds come out of the control
box – no movement.
·
The plug may not be mounted correctly.
·
Remove all cables from the control box, and mount
again.
·
Maybe a ”Reset” is needed. See the instructions below.
The frame seems loose and
unstable.
·
Tighten all screws of the frame, cf. the mounting
instructions.
The washbasin cannot be height
adjusted, or the height
adjustment feels very difficult.
·
Check that there are no jammed objects preventing the
height adjustment.
It takes too long for the water to
leave the washbasin. Check the siphon for clogging and clean it, if required.
Check that the flexible hose has not been positioned so
high on the wall that it acts as an additional siphon.
Check that connection hoses are not kinked or twisted on
the hose. Adjust the hoses so that they are not
kinked/twisted.