Ropox 40-44016, User Manual And Mounting Instructions

Page: 41 / 47

41
TF 200.01.0048_eng
5. Performance test
After installation and prior to use, all functions of Support Washbasin must be tested. The test must be
carried out by competent personnel. Subsequently the test shall be carried out at least once a year:
Testing prior to connection of mains voltage:
1. Check that the mounting instructions have been observed.
2. Check that all bolts have been tightened.
3. Check that all cables have been connected correctly and that the plugs have been pressed home.
4. Check that there is no load on the washbasin.
5. Check that there is nothing preventing the washbasin from moving freely within the height
adjustment range.
Connect main power to control box and continue testing:
1. Press and hold the UP and DOWN buttons and keep them depressed until the control unit has
beeped approx. ten times.
2. Press DOWN on the control switch, move the frame to bottom position, check that the movement is
even and smooth. Make sure that the hose connections follow the movement of the frame and that
they do not get squeezed. The frame is now reset.
3. Press UP on the control switch, move the frame to top position and check that the movement is even
and smooth. Make sure that the hose connections follow the movement of the frame and that they
do not get squeezed.
If all these tests are ok, the washbasin is ready for use. See section
“Safety instructions”.
6. Safety instructions
➢
The height adjustment of Ropox Support Washbasin Electric should only be operated by persons
who have read and understood these instructions.
➢
Do not use Ropox Support Washbasin Electric as a lifting table or person lifter.
➢
Always use the washbasin in a manner excluding the risk of damage to persons or property. The
person operating the washbasin is responsible for avoiding damage or injury.
➢
If the washbasin is used in publicly accessible locations where children or persons with reduced
observation capacity may get near it, the person operating the washbasin must pay attention to
those present in order to prevent dangerous situations.
➢
Make sure that there is free space above and underneath the washbasin to allow height adjustment.
➢
Do not overload the washbasin and make sure that the load distribution is correct.
➢
Do not operate the washbasin in case of defects or damage.
➢
Modifications, which may influence the operation or construction of the washbasin, are not allowed.
➢
Be aware that the washbasin becomes slippery when wet.
➢
Be aware that if there is water in the washbasin when it is height adjusted, it may spray on the floor.
➢
Be aware that if the drain stops when the water is running, the floor will get wet.
➢
Be aware that electrical cord does not get damaged during unit movement and exposes user to
electricity
➢
Be aware that user does not trip over remote chord
➢
Installation, service, and repairs should always be carried out by competent personnel.
➢
During inspections, service or repairs load should be removed from the washbasin.
➢
If purchased without covers, ensure no person or object is placed inside unit during actuation