Ropox 40-44000, User Manual

Page: 9 / 42

Page 9
© ROPOX 2017
Basic
(40-44002 and 40-44003)
CONSTRUCTION
The wall must be made of a material
suited for screw mounting and approved
for damp rooms.
The hatched area is the minimum area for
reinforcement of the wall.
Reinforcement from floor to ceiling is
advisable.
Load-tested in Accordance to DS/ISO
17966, the maximum user weight has
been fixed at 400kg (881 lbs).
Max. tensile load of upper screws
85kg/screw (187 lbs)
The washbasin is supplied with a set of 6
screws and rawlplugs suitable for
mounting on a concrete wall. The fitter
should always consider the material,
condition and strength of the wall and
use screws and rawlplugs suitable for
the specific wall type.
PLUMBING
The drain is Ø32
(1 ¼”) and ends in an
Ø32x88.5° drain elbow.
The maximum protrusion of drain
connection and elbow from the wall is
90mm
(3 ½”) to allow for the covers.
The water supply ends in 2 (two) 90°
shut-
off valves with ½” outside thread
pointing downward (not included).
The maximum protrusion of the shut-off
valves from the wall is 90mm
(3 ½”) to
allow for the covers.
It is important that all hoses for water
connection and drain are flexible to allow
the frame to move freely within the height
adjustment range of 710-1010mm
(28” – 39
8/10”) (including washbasin).
If a location of water supply and drain
different from the recommended positioning
is required or if there is a floor drain, the
Support Washbasin will have no covers.
For purchase of adapters for connection to
various standard installations, see
”Connection Adapters – Other Washbasins”.
NOTE:
The illustrations show the left-hand model 40-44002