5
6
CYCLE STATUS LIGHTS
The Cycle Status Lights show the progress of a cycle.
At each stage of the process, you may notice sounds or
pauses that are different from traditional washers.
FILL
When the START/Pause/Unlock Lid button is pressed,
the washer will fill to the selected water level. If the lid
is closed when the machine is done filling the lid will
lock and the machine will begin operation.
If the lid is open when the water stops entering the
machine, the cycle will not begin until the lid has been
closed and the START/Pause/Unlock Lid button is
pressed. If the cycle has not been started within
10 minutes of the water filling the washer, the washer
will pump out the water.
NOTE:
Avoid opening lid during sensing phase. The
sensing process will start over when the washer is
restarted. The fill light may also come on during
the Soak and Wash portions of the cycle. This is
normal. To restart the washer after the lid has been
opened press start.
WASH
You will hear the agitator moving the load. The motor
sounds may change at different stages in the cycle.
The wash time is determined by the selected soil level.
RINSE
You will hear sounds similar to the wash cycle as the washer
rinses and moves the load. You may hear the motor turning
on briefly (short hum) to move the basket while filling. Fabric
softener will be added if the Fabric Softener knob was set to
YES.
Some cycles use spray rinsing. After draining and spinning
out wash water, the washer will continue to spin and spray
in rinse water for the entire rinse time.
FINAL SPIN
The washer spins the load at increasing speeds for proper
water removal, based on the selected cycle and spin speed.
CYCLE COMPLETE
Once the cycle is complete, this light will come on.
Remove the load promptly for best results.
LID LOCKED
To allow for higher spin speeds, the lid
will lock and the Lid Locked light will turn
on. When this light is on, the lid is locked
and cannot be opened. When this light is
blinking, the washer is paused. When this
light is off, the lid can be opened.
If you need to open the lid, press START/
Pause/Unlock Lid. The lid will unlock once
the washer movement has stopped. This
may take several minutes if the load was
spinning at high speed. Press START/Pause/
Unlock Lid again to resume the cycle.
Summary of Contents for W10420470C
Page 2: ...2 WASHER SAFETY ...
Page 16: ...16 SÉCURITÉ DE LA LAVEUSE ...
