13
C
OMMON WASHING PROBLEMS
(
CONT
.
)
Solution...
•
Plug in power cord.
•
Turn timer knob to the right slightly
and pull to start.
•
Clean screens.
•
Turn on water.
•
Reverse hoses.
•
Straighten hose.
•
Plug in power cord.
•
Check electrical source or call
electrician.
•
Replace fuse or reset circuit
breaker. If problem continues,
call electrician.
•
Do not use extension cords.
•
Turn timer to the right slightly
and pull to start.
•
Set and pull out knob.
•
Wash smaller loads.
•
This is normal.
•
Push tub to center before
starting.
•
This is normal.
•
Ensure front feet are installed
and nuts tightened. Level
washer. Reset rear leveling legs.
See Installation Instructions.
•
Sort lint givers (towels, chenille)
from lint takers (corduroy,
synthetics). Also sort by color.
•
Lint can be trapped in load if
overloaded. Wash smaller loads.
•
Clean out pockets before washing.
•
Use enough detergent to hold
lint in water.
•
Use wash water warmer than 70°F
(21°C).
•
Use wash water warmer than 70°F
(21°C).
Cause...
•
Power cord not plugged in.
•
Timer (Cycle Control knob) dial
is not lined up.
•
Water inlet valve screens are plugged.
•
Water is turned off.
•
Hot and cold hoses are reversed.
•
Inlet hose is kinked.
•
Power cord not plugged in.
•
No power at plug.
•
Fuse blown or circuit breaker open.
•
Using an extension cord.
•
Timer dial is not lined up.
•
Timer knob not pulled out.
•
Machine is overloaded.
•
The top of the agitator is much higher
than the highest water level. This creates
a perception of the washer not being full.
•
Tub is pulled forward when unloading.
•
Tub moves.
•
Unit not level.
•
Improper sorting.
•
Overloading.
•
Paper or tissue in pockets.
•
Not enough detergent.
•
Detergent not dissolving.
•
Wash water colder than 70°F (21°C).
Problem...
Won’t fill/rinse/agitate
or wrong tempera-
ture
Washer stops
Water level seems
too low or washer
not completely filling
Washer tub is
crooked
Residue or lint
on load
TROUBLESHOOTING
continued on next page
