ROOTS RootsScrub RB 800 C, Operator'S Manual, Page: 16 / 23

16
RootsScrub RB 800 C
Compliance with our recommendations concerning
maintenance work will give you the certitude always having
a machine at your disposal, which is ready to work and in
good operating condition. Please contact your local
distributor; the people there will be glad to perform that
work for you.
- Well trained personnel and genuine spare parts are at your
disposal.
- In case of any inquiries or orders for spare parts, please
always quote the machine's serial number mentioned on
the nameplate.
- The name plate is fixed in the rear side of the machine.
- When cleaning or servicing the machine, and when
replacing any parts, shut off the machine and on principle
disconnect the power plug from the power supply.
- For reasons of safety during cleaning and/or maintenance
work in or on the tank, the tank lid - when lifted - must be
secured so as to prevent accidental closing or tilting down.
- The machine may be taken into operation only if all
guarding devices are fitted and in protective position. As
far as possible, cleaning should not be done by hand, but
using appropriate tools or equipment.
- Maintenance and repair work may be carried out only by
means of suitable tools and by the people trained in the
factory - for reasons of safety, only genuine spare parts may
be used.
Maintenance Work Maintenance Schedule
daily every 50 every 200 every 500
Recharge batteries according to charger unit
instructions
Empty and clean dirty water tank
Check condition of squeegee lips
Check squeegee for foreign particles taken
and clean if required
Clean filter in fresh water tank
Check battery poles and apply grease if
required
Check tight fitting and condition of suction
hose between squeegee and dirty water tank
Check squeegee lips for wear and turn or
replace if required
Check brushes and water retaining ring for
tight fitting and condition and replace if
required
Check function of float
Check rotational direction of the brushes
Check function of brake
Check squeegee holder and castor roller, re-
adjust if required
Check fresh water supply to the brushes
Clean traction motor from carbon dust and
check the accessible carbon brushes for
smooth running and condition, replace if
required
Clean electro-motor from carbon dust and
check the accessible carbon brushes for
smooth running and condition, replace if
required
Grease steering pinion and gear ring
Check joints at squeegee holder and grease if
required
Service Hours
Maintenance Table
Greasing Points
Greasing point
MAINTENANCE