ROOTS RootsScrub RB 800 C, Operator'S Manual, Page: 11 / 23

11
RootsScrub RB 800 C
BRUSH
Cylindrical Brush Head
Clean the cylindrical brushes on the brush head daily or as
necessary.
1. Raise the brush head.
2. Remove the rubber deflector stip assembly (a) by unscrewing
the knobs.
3. Unscrew the idler plate securing pin (b).
4. Raise the idler plate assemble (c) upwards to access the
brushes.
5. Pull out the brushes (d) to clean or to rotate them end-to-end.
Cleaning the cylindrical brushes
Do not use harsh acids or chemicals to
clean the brushes.
1. Slide the brush (d) in the cylindrical brush head and allow
to snap into place on the oppositely facing catches.
2. Clock the idler plate assembly (c) and secure it with the pin
(b) provided.
3. Mount the rubber deflector stip assembly (a).
1. Lift the debris tray upwards a little to facilitate easy
removal of the tray from its retaining position.
2. Empty the debris in an approved manner.
3. Clean the debris tray and place it back on the brush head.
Installation of cylindrical brushes
Cleaning the debris tray
I. Drive Motor Malfunction
warning lamp-
Glows when there is an error
in the drive motor or controller. M
J. Battery Charge status
indicator lamp-
Shows the status of the
battery.
K. Hour meter & Error Code
Display-
Displays the total hours of machine
use and any error in the electronic
module.
L. Water level indicator-
Displays the level of water
selected.
M. Water level controls-
Used to On/Off,
Increase/Decrease the amount
of water to clean the floor.
a
c
d
b
Switch off machine before changing brushes.
Care should be taken while mounting brushes.
Do not stand on the brush head.
Do not empty the debris into the
environment.
Switch off machine before removing the debris
tray.
Care should be taken while removing the debris
tray, may injure your hands.