ROOTS RootsScrub E4043, Operator'S Manual

Page: 25 / 40

25 RootsScrub E4043
MACHINE OPERATION
è
Raise brush head (e).
è
Close water flow completely (c).
è
Switch Off brush motor (a).
è
Switch Off suction turbine (b).
è
Raise squeegee completely (d).
è
Switch Off mains.
è
Unplug power cord.
è
Drain dirty water tank completely in an approved waste
water disposal area.
End of Scrubbing:
è Move machine to waste water disposal area.
è Lower the dirty water tank drain hose (a) to the floor drain.
è Slowly open the drain hose cap (b) to let the dirty water flow
out.
è
Wait till the dirty water tank is completely empty.
è
Clean the dirty water tank with clean fresh water.
è
Close the drain hose cap and secure the drain hose to the
machine.
DRAINING DIRTY WATER TANK:
POST-SCRUBBING CHECKPOINTS:
WARNING:
DO NOT drain the dirty water into the environment.
There is a risk of contaminating the environment.
WARNING:
è
Do not clean the machine by means of a
vapor jet or a high pressure cleaning
equipment. Clean the brush head with a
water hose (pressure: 3 to 4 bar max.) and from the bottom
only.
è
Do not direct the water jet into any opening, slots, on
electronic modules, control panels or sealing.
è
Do not use harsh chemicals to clean the machine.
=
Check the tank lid seals for damage or wear and tear.
=
Clean the float.
=
Check the condition of the brushes. Remove any string, rope
or other debris wrapped around them.
=
Check the vacuum hose for block/damage.
=
Check if both the tanks are completely clean.
=
Check the machine exteriors for any damages or dirt.
=
Check if the squeegee knobs are tight.
b
a