3. Open the lateral brush head cover by loosening the
screw. Then insert the enclosed brushes into the
housing. The machine has been equipped with
screws to facilitate removal and fastening of the
brushes.
4. After folding of the lid, filling of the fresh water tank is
possible. Before filling with fresh water, take the
support roller out of its parking position.
Make sure that all covers and flaps have been
fitted before starting operation.
A damaged mains cable has to be replaced by
specific cable available at the manufacturer
or an Authorized service center.
1.Adjustable handle
2.Button for Handle
3.Squeegee Governor (forward, reverse)
4.Screw for brush removal
Operating & Indicator Elements:
OPERATING & INDICATOR ELEMENTS
Make sure that the mains cables are not damaged by
passing over them by pinching, pulling or other impacts.
Check the mains cables for ageing and damages at
r e g u l a r i n t e r v a l s . R e p l a c e t h e m b y t h e t y p e
H05VVF3Gx1.5 as specified by the manufacturer. When
replacing the coupling plug of the mains cable or when
connecting lines respect the splash water protection and
the tensile strength of the components.
Handling Mains Cable Assembly
1
2
3
4
Screw
Ÿ
Brush motor
Ÿ
Suction motor
Ÿ
Water pump switches
Controls
Control panel
A. Brush motor switch ON / OFF
Ÿ
Function in ON if switch “A” is in position “I”
B. Suction motor switch ON / OFF
Ÿ
Function in ON if switch “B” is in position “I”
C Water pump switch ON / OFF
Ÿ
In “I” position of the switch, water is steadily pumped
to the floor.
Ÿ
In “0” position of the switch, no water is pumped.
2. Detergent infeed
Pump Switch
Ÿ
The machine allows mixing of cleaning lye and fresh
water in the tank. The amount of detergent required for
cleaning can be regulated by the pump switch. If the
switch is set to the position “I” the cleaning lye is
continuously supplied. If the solution is required by
intervals only, press the switch and hold in position “I”.
This function helps to save detergent.
Knob
9
RootsScrub E 350
A
C
B