ROOTS RootsScrub B6060, Owner'S Manual, Page: 13 / 21

13
RootsScrub B6060 & B6060x
Raising / Lowering the Squeegee
Ÿ
To lower the squeegee pull the handle up from the
slot and lower squeegee.
Ÿ
To raise the squeegee pull the handle up and place
in slot provided.
Squeegee handle
movement
PROCEDURE FOR SCRUBBING
OPERATION SQUEEGEE
Dirty and Fresh Water Tanks
The machine has a Dirty Water Tank and a Fresh Water
Tank. The filling capacity is 60 liters. Please do not fill
beyond that mark; water temperature must not exceed
50°C. Dirty water is fed via the suction hose into the dirty
water tank.
- Do not collect any external water.
- When work is finished both the dirty and the
fresh water tanks on principle must be drained
and rinsed in order to preclude formation of
residues.
For disposal of dirty water and lye, the legal
provisions have t o b e c o m p i l e d w i t h .
Check the in-feed filter in the tank regularly and
clean it if required.
Filling of Water
Ÿ
Fill fresh water and cleaning solution as described
below before start of operation.
Ÿ
Fill the fresh water tank with water (50° max) as
required by the work to be done through the filter
which is present in front of the machine and add
detergent as specified by the manufacturer.
Ÿ
Filling amount : 60 liters Max.
max 50°C
Max water
level
1
1
1
2
Use cleaning solution suitable for automatic
machines (low foaming) in order to preclude
damages at the suction turbine. We recommend
our agents for cleaning and care, which are
perfectly adopted to the machine. These
products fulfil the requirements of the cleaning
solution act.
How to operate the machine:
Lever to adjust
flow of water
For B6060
(Refer Controls section of B6060 in First Operation)
Ÿ
Turn on Switch “B” the brush is rotating.
Ÿ
To discharge the detergent, position the lever
suitably to achieve the desired flow of detergent.
Ÿ
Lower the brush head.
Ÿ
Lower the squeegee.
Ÿ
Turn on switch “C” the suction turbine is running.
Ÿ
As soon as the suction turbine is switched on
operate the lever to start water flow.
Ÿ
The water flow can be adjusted to suite the floor.
Ÿ
The water flow is maximum when the lever is in top
position.
Ÿ
The water flow is minimum or to stop when the lever
is in bottom position.
Ÿ
Water flow is controlled by mechanical stopper.
For B6060x
(Refer Controls section of B6060x in First Operation)
Ÿ
Turn on Switch “C” the brush is rotating.
Ÿ
To discharge the detergent, position the lever
suitably to achieve the desired flow of detergent.
Ÿ
Lower the brush head.
Ÿ
Lower the squeegee.
Ÿ
Turn on switch “D” the suction turbine is running.
Ÿ
As soon as the suction turbine is switched on
operate the lever to start water flow.
Ÿ
Turn on switch “B” for water flow control.
Ÿ
The water flow can be adjusted to suite the floor.
Ÿ
The water flow is maximum when the lever is in top
position.
Ÿ
The water flow is minimum or to stop when the lever
is in bottom position.
Ÿ
Water flow is controlled by solenoid valve.