Roothog SODHOG, Operating And Assembly Instructions Manual, Page: 6 / 9

Page 6
2. Attach the Shield (Item 1) to the long open slot of the arm with two Carriage Bolts (Item 5),
Washers (Item 6) and Wing Nuts (Item 7). Secure only finger tight.
3. Attach entire Shield Assembly to the power shaft above the cutting head using a Carriage
Bolt (Item 4), Washer (Item 6) and Wing Nut (Item 7).
4. Adjust the Shield Clamp and Shield up/down/in/out to ensure the shield is aligned completely
over the SODHOG.
SPECIAL NOTE : Prior to operating the Sodhog, be sure to tighten the edger handle to prevent movement
and if equipped with a depth wheel, either remove or rise and secure the wheel in the up position.
Secure all Wing Nuts securely in place.
CHAPTER 4
REPLACMENT PARTS LIST
P
A
R
T
Name
Part #
U/M Qty Destination
1 Hub HB3000 Each 3 All Models
2 Carbide Chain Loop CC7000 Each 11 HUB (Super-Tooth Sodhog)
only)
3 Chain Loop RC7000-
R
Each 11 HUB (Sodhog)
4 Adapter AS7000 Each 3 All Models
5 Spacers SS2000 Each 38 All Models
Hex Bolt 3/8x20x6" HB1000 Each 1 All Models
6 Washer, Outside WO1000 Each 1 All Models
7 Washer, Inside W2000 Each 1 All Models
S
h
i
Shield, Safety SA5000 Each 2 All Models PART
NUMBER
TYPE QUANTITY DESTINATION
Arm, Attachment AA1000 Each 1 All Models
Clamp, Attachment CL1000 Each 1 All Models
Carriage Bolt 1 1/4" CB1200 Each 4 All Models
Carriage Bolt 1 1/2" CB1300 Each 1 All Models
Carriage Bolt 2" CB1400 Each 1 All Models
Washer, 1/4" W200 Each 6 All Models
Lock Washer 3/8" W430 Each 1 All Models
Wing Nut 1/4" WN100 Each 1 All Models
Pin, Assembly PA606 Each 2 All Models
Safety & Operation
Manual
SO1500 Each 1 All Models
All non-metallic parts of the Sodhog are made from 6-6 high impact nylon.
All parts proudly
MADE IN THE UNITED STATES