11
LIGHTING INSTRUCTIONS
Lighting the Fire Table
1. Read and understand all operating instructions before lighting.
2. Before beginning, make sure the key valve is in the OFF position.
3. Connect your propane cylinder (see previous pages).
4. Position a burning long match or long burning butane lighter near the side of the burner.
5. Insert the valve key and slowly turn the valve counterclockwise towards the ON position.
6. Once the burner has been lit, remove the long match/ long butane lighter. Observe the flame
and make sure that all the burn ports are lit.
7. Adjust the flame to the desired height using the key valve.
8.
WARNING:
If ignition does not occur in 15 seconds, turn the key valve to the “OFF” position
and turn the gas off at the tank. Make sure there is no source of ignition around the fire table
and wait at least five minutes until the gas has cleared to repeat the lighting procedure. Failure
to do so could result in a large flashback of pooled gas, causing property damage or injury.
1. Using the key, turn the valve to the OFF position.
2. Once the flame is out, remove the key, and turn the gas off at its source.
3. Store the key in a safe location.
Shut-off Instructions
Flame Height
8-14”
20.3-35.5 cm
OFF
ON
KE
Y V
AL
VE
