PRODUCT MANUAL
58-62ST Above Deck Compact Motor
™
10
STEP 4
Install motor unit.
Having a second person to assist during this step may help to avoid fouling the wiring and drain tube with sealant as they are
passed through the deck.
4.1 Apply sealant to the deck to prevent water ingress. In addition to sealing the mounting holes, apply a bead of sealant
around the perimeter of the base to form a completely watertight seal.
NOTE
: For mounting on metal surfaces, the base must also be completely isolated from the mounting surface to prevent
galvanic corrosion.
4.2 Fit the motor unit [1] to the deck using the appropriate length ISO 4762-A4-M6 or 1/4” bolts, large washers or backing
plate, and locking nuts.
4.3 Place the stainless steel cover [2] back on the motor unit and slide it down into position.
STEP 5
Install push button
The push button [A1] requires 50mm (2”) clearance depth below the
mounting surface. It is supplied with a short 190mm (7 1/2”) long cable
lead; this is connected below deck to the 1000mm (39”) long control
cable [A9] and then to the short cable leads from the motor. Extension
cables are available and may be ordered separately if necessary.
5.1 Select the desired location. For safety reasons it is
recommended that the push button [A1] is located in close
proximity to the winch, preferably within reach.
5.2 Determine the preferred orientation of the hinged cover (on
vertical surfaces it should open upwards). Then using the
drilling template or the rubber gasket [A2] as a guide, drill a
Ø25mm (1”) hole.
5.3 Drill a Ø3mm (1/8”) hole in each of the three mounting screw
locations.
5.4 Fit gasket and push button in place. Secure the push button unit
with the 3x M4x20mm self tapping screws [A7], using a small
amount of sealant at each hole.
5.5 Ensure that the breather channel on the side of the through-deck
tube of the push button is clear and free of dirt or sealant.
Breather
channel
Drilling
template
Mounting
screws
Hinged
cover
Push
button
Rubber
gasket
Push button installation