RH560WIRELESS CMS OPERATION MANUAL
Page 14/15
7. Product maintenance and fault elimination
7.1
Maintenance
We suggest to have dust elimination, anti
‐
corrosion inspection and other operations every 3
months. If the equipment is not be used for long time, please power off and keep it in dry and no
corrosive gas environment.
7.2
Fault analysis and elimination
When there is problem with the equipment, please check it according to the following table,
if the problem still can’t be solved, please contact technical department of RONDS company.
Fault type
Possible reason
solution
RH560
‐
WL RUN LED is not
light
Power disconnected or switched
off
Check power supply and switch
Normal communication but
now data collector
displayed in online service
RH560
‐
WL or server IP setting is
not associated with each other
Check configuration info.
All sensors have no data
RH560
‐
WL
disconnected
with
server
Check RH560
‐
WL power supply and
configuration info.
Some sensors have no data
RH505 switched off or error
configuration info.
Check
RH505
switch,
PANID,
frequency band and IP info.
Some sensors data is not
correct
Low battery voltage of RH505
Check battery condition from online
service
FCC STATEMENT :
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two
conditions:
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received, including interference that may cause
undesired operation.
Warning:
Changes or modifications not expressly approved by the party responsible for
compliance could void the user's authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation. This equipment generates
uses and can radiate radio frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception, which can be determined by turning
the equipment off and on, the user is encouraged to try to correct the interference by one or
