Ronde & Schwarz 1304.0004.03, User Manual

Page: 714 / 1076

Remote Commands
R&S
®
FPL1000
714 User Manual 1178.3370.02 ─ 09
Manual operation: See "Results" on page 229
CALCulate<n>:MARKer<m>:FUNCtion:SUMMary:SDEViation[:STATe] <State>
This command turns the evaluation to determine the standard deviation of the time
domain power on and off.
The R&S FPL1000 performs the measurement on the trace marker 1 is positioned on.
Suffix:
<n>
.
Window
<m> Marker
Parameters:
<State> ON | OFF | 1 | 0
*RST:
0
11.6.10.2 Performing a Time Domain Power Measurement
The following commands are required to perform a Time Domain Power measurement:
INITiate<n>[:IMMediate]
on page 629
See Chapter 11.6.1, "Performing Measurements" , on page 626
11.6.10.3 Retrieving Measurement Results
The following commands query the results for time domain measurements.
Measuring the Mean Power
CALCulate<n>:MARKer<m>:FUNCtion:SUMMary:MEAN:AVERage:RESult?
....................... 714
CALCulate<n>:MARKer<m>:FUNCtion:SUMMary:MEAN:PHOLd:RESult?
.......................... 715
CALCulate<n>:MARKer<m>:FUNCtion:SUMMary:MEAN:RESult?
......................................715
CALCulate<n>:MARKer<m>:FUNCtion:SUMMary:MEAN:AVERage:RESult?
This command queries the average mean time domain power. The query is only possi-
ble if averaging has been activated previously using
CALCulate<n>:MARKer<m>:
FUNCtion:SUMMary:AVERage
on page 711.
To get a valid result, you have to perform a complete measurement with synchroniza-
tion to the end of the measurement before reading out the result. This is only possible
for single sweep mode.
See also
INITiate<n>:CONTinuous
on page 628.
Suffix:
<n>
.
Window
<m> Marker
Return values:
<MeanPower> Mean power of the signal during the measurement time.
Configuring and Performing Measurements