X11CB INSTALLATION AND OPERATION
2). Insert the clamp part A into the groove of the clamp part B as shown in the figure
below.
Illustration 35: Assembling the Clamp Parts
3). Place the first clamp into the center of the groove behind the extruded trim of the
cabinet and then slide it into about one third from the top left corner of the cabinet.
Illustration 36: Inserting the Clamp into the Top
Center of Cabinet Groove
Place the second clamp into the center of the groove behind the extruded trim of
the cabinet and then slide it into about one third from the top right corner of the
cabinet. Tighten each jam screw to secure the cabinet to the panel cutout. Tighten
the lock nuts on each screw.
The cutout size is approximately 0.5 inches larger than the Actual Height and Width
giving 0.25 inch leeway around the perimeter.
38
X11CB-3031-IOM
