Rona 2001519, Operating Manual, Page: 6 / 11

10
GB
11
GB
KNOW YOUR PRODUCT
Description of symbols
The rating plate on your tool may show
symbols. These represent important
information about the product or instructions
on its use.
Wear hearing protection.
Wear eye protection.
Wear breathing protection.
Double insulated for
additional protection.
Conforms to
CAN/CSA-C22.2 No. 745-1-95
CAN/CSA-c22.2 No. 745-2-4-95
UL 745-1-95
UL 745-2-4-95
Environmental protection
Recycle unwanted materials
instead of disposing of them
as waste. All tools, hoses and
packaging should be sorted, taken
to the local recycling centre and disposed of in
an environmentally safe way.
Specifications
Voltage: 120V ~ 60Hz
Power rating: 4Amp
No load speed: 4000-11000 RPM
Sandpaper type: Hook and loop
Random orbital sanding
sheet size:
Ø5”
Net weight: 6.61 Ibs (3 kg)
This sander is double insulated. There are two
independent barriers of insulation to protect
you from the possibility of electric shock.
General safety instructions
WARNING. Read and understand all
instructions. Failure to follow all instructions
listed below, may result in electric shock, fire
and/or serious personal injury.
Save these instructions.
Work area
• Keep your work area clean and well lit.
Cluttered benches and dark areas invite
accidents.
• Do not operate power tools in explosive
atmospheres, such as in the presence of
flammable liquids, gases, or dust.
Power
tools create sparks which may ignite the
dust or fumes.
• Keep bystanders, children, and visitors
away while operating a power tool.
Distractions can cause you to lose control.
Electrical safety
• Double insulated tools are equipped with
a polarized plug (one blade is wider than
the other.)
This plug will fit in a polarized
outlet only one way. If the plug does not fit
fully in the outlet, reverse the plug. If it still
does not fit, contact a qualified electrician to
install a polarized outlet. Do not change the
plug in any way. Double insulation eliminates
the need for the three wire grounded power
cord and grounded power supply system.
• Avoid body contact with grounded
surfaces such as pipes, radiators, ranges
and refrigerators.
There is an increased risk
of electric shock if your body is grounded.
• Do not expose power tools to rain or wet
conditions. Water entering a power tool will
increase the risk of electric shock.
• Do not abuse the cord. Never use the cord
to carry the tool or to pull the plug from
an outlet. Keep the cord away from heat,
oil, sharp edges or moving parts. Replace
damaged cords immediately. Damaged
cords increase the risk of electric shock.
• When operating a
power tool outside, use
an outdoor extension
cord marked “W-A”
or “W”.
These cords are
rated for outdoor use
and reduce the risk of
electric shock.
DESCRIPTION, SPECIFICATIONS
AND INSTRUCTIONS
1. Auxiliary handle
2. Auxiliary handle lock knob
3. Sealed on/off switch
4. Variable speed control
5. Rubber grip handle
6. Dust canister 7. Dust extraction port
8. Hex key
9. 5” sanding base
10. Dust extraction adaptor piece
11. Washable dust bag
Parts list
1
2
3
4
5
10
6 7
8
9 11