Page
1
of
10
Copyright ROMPA® Ltd
WATER MATTRESS MASSAGE SYSTEM 20439, KH 4.11
WATER MATTRESS MASSAGE SYSTEM 20439
CONTENTS
Massage System with Controller
Please note
: the above image shows a white unit and a blue unit. The white unit is supplied
inside the blue unit – the image is for illustration purposes only – to indicate where the motors
(black circles) are located.
BEFORE USE
•
The massage unit can be fitted when the water bed foam frames are in place.
•
Bed with dual mattresses: be aware that the massage unit is placed in the corner (see
1
below) so that it is not covered by the divider.
•
The heating element is placed on the massage unit where stated. It is important that
both vinyl and the heating element are lying flat.
•
The cable from the heating element is led through the hole in the massage unit (see
2
below).
•
Lead the cables from the heating element and the massage unit under the massage unit
and foam and through the hole in the bottom part of the cover. See also instructions for
the waterbed model in question.
•
Unpack and check that all components are intact.
•
Connect the power supply and controller to the Massage System unit as shown below:
