12.
Technical Specification
Size:
1mL (1070 x 65 x 88mm)
Power:
240V – 50Hz (mains lead supplied)
Consumption: 50W
Fuse in plug: 13A (UK plug)
Lamp life:
100,000 hours
Weight:
2.5KG
CE:
Meets requirements of CE and RoHS
13.
Installation
1.
Install indoors in dry environments only
2.
This product requires one electrical socket.
3.
If this product has been exposed to extreme temperatures during transportation, do
not switch on immediately. Allow the product to reach room temperature first.
4.
Use the integral bracket to wall or ceiling mount this product. There are two holes in
each of the two brackets for fixings. Fixings are not included as these depend on the
construction of your wall/ceiling.
5.
This unit weights approximately 2.5kg. Please take this into consideration when
fixing. Please make sure that you are aware of the construction of the wall the unit is
to be fixed to. Taking this into account please ensure you have the correct fixings.
For example walls may be partition walls and plaster board as opposed to solid brick
or stone walls. Take advice from a suitably qualified professional builder or from an
estates department if in any doubt about appropriate fixings. Make sure your wall
and fixings are capable of holding the weight of this product.
6.
Adjust the angle of the wall washer as required by gently pivoting the head
containing the LEDs at the brackets. We recommended that the wall washer is
pointed towards a wall. The lights are bright and it is not advisable to position the
wall washer in such a way that would encourage/allow users to look directly into it.
7.
Multiple wall washers can be used together. Only one wall washer is supplied.
8.
Plug the wall washer in at the wall.
OPERATION
Plug in. There is no ON/OFF button. This product is not intended to be switched ON and OFF
at short intervals.
The unit enters automatic mode where it will slowly cycle through all the colours.
If it receives a Wi Fi signal (transmitted from another Wi Fi enabled ROMPA® device such as
a Colour Changing Panel) the unit will change to the corresponding colour sent, for one
minute at which it will resume automatic cycling unless another Wi Fi signal is received in
this time.
