Copyright ROMPA® Ltd
ELECTRIC AIR PUMP 18682, KH 2.06
To Deflate
•
Plug in at electrical wall socket (AC 230V).
•
Open the valve of the inflated item.
•
Attach the adapter to the deflation port through
the deflation vent
B
then insert it into the valve.
•
Switch on to start inflation (switch to ‘I’).
•
The valve of the inflatable item should not be
obstructed – otherwise it could overheat and
damage the pump.
•
For inflatable items with small valves, pinch the
valve between your fingers to open the flap of the
valve and allow air to escape.
•
For inflatable items with screw-type valves, remove these as necessary
•
Switch
off
F
(switch to ‘O’) after use.
CARE & MAINTENANCE
Handle the pump with care, observing the advice in these instructions.
SAFETY
Always supervise the use of this product
For use by a competent adult
Do not expose to rain/damp.
Store indoors, in a safe place, out of reach of children/anyone you would not want to find it.
Do not operate the pump for more than 30 minutes at one time.
Do not allow to overheat.
Do not use an extension cable
Should you damage the cord/pump, contact a suitably qualified electrician. Cease use till
repaired/replaced.
Do not exceed the given pressure/size of the item you are inflating. Otherwise injury could
result as the item bursts.
Never leave the pump unattended whilst it is plugged in/in use.
Use (and store) in dry environments only.
Never look inside or point the inflation port
D
/deflation port
E
towards eyes when the pump is in
operation.
Never attempt to put hands or fingers into the inflation port
D
/deflation port
E
at any time.
SPECIFICATION
AC 230V