Page
1
of
11
Copyright ROMPA® Ltd
SOUTHPAW HEIGHT ADJUSTER 13626, KH 9.10
SOUTHPAW HEIGHT ADJUSTER 13626
A Safety Rotational Device 13738
must
be used with the Height Adjuster - see ROMPA
®
Catalogue.
Please note: this product is for lowering/raising equipment NOT clients. This is NOT a
hoist.
CONTENTS
1. Height Adjuster with Safety Snap
2. Maintenance Checklist
NOTE: The Height Adjuster requires a minimum ceiling height of 8 feet/2.5 metres.
Working load: 1000 lbs
OPERATING INSTRUCTIONS
No assembly required.
1.
Push the safety trigger
A
up to open the cam gate.
See Figure 1.
2.
Insert your rope.
See Figure 2.
3. To move the Height Adjuster up:
•
hold the rope firmly below the Adjuster – at point
B
•
push the Adjuster upwards
•
Release the cam gate and push down on the safety trigger
A
to ensure the rope is firmly held.
4. To move the Height Adjuster down:
•
hold the rope firmly below the Adjuster – at point
B
•
push the safety trigger upwards while applying upward
pressure to the Adjuster. This releases the rope and the
Adjuster can now be moved down.
•
Release the cam gate and push down on the safety trigger to
ensure the rope is firmly held.
See Fig. 3
MAINTENANCE CHECKLIST
All parts of the Height Adjuster and its Suspension System should be checked on a monthly
basis and a record kept on the Maintenance Sheet provided.
On the Height Adjuster check for:
•
bent or broken cam tips
•
failure of cam to close
