Use the projector’s bracket to mount the projector in any of the following ways:
Ensure that the projector is secured to a surface or structure able to bear the weight
of the projector and accessories, via the bracket fitted using suitable central bolt
(minimum: 14mm M10 x 20mm), washers and attachments.
A safety chain or cable must be fitted to the projector and secured to an immovable
object.
The mounting point must be able to support the weight of the projector should it fall.
Adjust the angle and position of the effects projector using the knob which
connects the bracket to the unit. Loosen the securing lever and move bracket to
the desired position. Tighten lever securely. To adjust the position of the lever
press the central button, pull lever away from the projector, turn to the desired
position and release.
Place a suitable accessory in the projector e.g. Wheel Rotator with an Effect
Wheel. Slide the Wheel Rotator into the rear gate runners (the main effect goes into the
rear gate runners, with Distortion Wheels etc in the front gate runners). Once the effects
are in place, connect these to the 12V~ sockets on the side of the Projector.
Plug in the main 12V~ transformer into a mains socket
and switch on if necessary. Next, plug the other end of
the lead into the 12V ~ socket on the rear panel. Then
turn the projector on by the mains switch to the “I” (ON)
position.
Focus the projected image by twisting the lens in and out until the desired focus is
achieved. During focusing beware of rotating the projection lens too far out as this
can cause the lens to separate from the projector and may drop and break or cause
injury.
