Step 1 - Wall Profile Position
1. Dry fit the Bath Screen on top of the Bath. Position the Fixed Panel so that the curved face of the bottom
Pivot Assembly falls in line with the inside of the Bath.
2. Using a pencil lightly mark where the aluminium vertical profile touches the Bath Top (use masking tape to
protect the Bath), this will determine where you need to fix the Wall Profile in Step 2.
• You must ensure the glass runs parallel to the outside edge of the bath before marking the Bath Top.
• You will need help to hold the screen in position while you mark the tiled wall and bath top.
• IMPORTANT INFORMATION: Failure to fit the fixed panel to the inside edge of the bath top will result in the
bath screen leaking and will not be covered under the terms of the guarantee.
①
Inside edge of bath
Pivot
Assembly
NOTE: Two people will be required to do the following procedures.
②
Lightly mark position
using a pencil
Align to the
top inside
edge
①
