Step 2 - Fitting the Wall Profile.
1. If fitting to a tray the glass slot in the wall profile must be in line with the glass groove in the tray as shown above. Using a
pencil mark the locations for the drill holes on the wall surface using the holes in the wall profile as a guide.
•
The wall profile must be completely vertical (the bubble should be in the centre of the two lines on the spirit level).
•
The screws down the side of the wall profile must face in towards the showering area.
•
The glass slot must be in line with the glass groove in the tray (the outside edge of the wall profile will be
approximately 15mm in from the outside edge of the tray).
2. Drill the holes using 6mm masonry drill bit (not supplied). Push the wall plugs (supplied) into the drilled holes.
3. Apply a bead of silicon the width of the wall profile at the bottom where it meets the tiled wall.
Important:
failure to carry out this procedure can result in serious water damage and is not covered under the
terms of the guarantee.
4. Screw-fix the wall profile to the wall using the 40mm screws (supplied).
Important:
no sealant should be present between the wall profile and the tiled wall vertically prior to screw- fixing.
➂
➃
➀
➁
➀
Glass Groove
SNCW-SNWCG:CQB
14/5/10 11:35 Page 3