Assembly & Care Instructions
Distributed by
Companion Brands
Bundoora VIC 3083
www.companionbrands.
com.au
TO ASSEMBLE:
Part No. 560134
1. Select a cleared level site and be careful to avoid hanging
branches, excessive wind and areas where water could pool under
your tent. It may be necessary to dig a trench around your tent to
divert water flow.
2. Layout the inner tent on an area free of sticks, stones, and ants
nests etc.
3. Peg down the corners of the inner tent. Leave the mesh door(s)
closed to avoid unnecessary pressure on zips.
4. Assemble the two longer BLACK fibreglass poles (A) and lay them
across the tent diagonally from corner to corner.
5. Feed both poles through the ceiling sleeves of the inner tent (Fig.1).
6. Insert the corner pins into the metal ferrule at the end of the
fibreglass poles.
7. Raise the poles to form an arch over the centre of the tent and
attach all of the ‘C’ clips to the poles (Fig.2).
8.
Feed the remaining GREY fibreglass pole (B) through the sleeve on
the outside of the flysheet.
Place the flysheet over the tent frame (with all zipper closed) and
make sure that the door opening corresponds with the opening of
the inner tent (Fig.3).
9. Peg down the rear corners of the flysheet and then connect the
ends of the GREY fibreglass pole to the remaining pins on the front
corners of the inner tent. Then peg down the perimeter of the fly.
10. From under flysheet, attach flysheet to poles using material ties.
11. Extend all guy ropes and peg down securely (Fig.4).
IMPORTANT
Ensure all zips are closed during erection of your tent. If the zips are
open, the dome can be pulled out of shape and create undue stress on
the zips when trying to close them.
All guy ropes are to be pegged at their full length at all times. Damage
caused to your tent by not fitting the guy ropes at their full length will
not be covered by warranty.
REMEMBER
Always ensure your tent and poles are clean and dry before packing
them away.
CARE INSTRUCTIONS
Always clean and dry your tent thoroughly before packing it away.
Storing a wet tent will cause mildew and will dramatically shorten
the life of the fabric.
Only clean your tent with warm water (not hot) and a sponge.
Do not use any type of detergent as this may damage the fabric.
Do not store directly on concrete floors.
WARRANTY
This product is covered by a 12 month warranty from the original date of purchase.
The warranty covers faulty workmanship and/or materials and will be repaired or
replaced at the discretion of Primus Australia. To make a warranty claim, return the complete
tent to your place of purchase along with your proof of purchase (the customer must bear
any cost of freight). The Escape II Series dome tent is designed for recreational use only and
is not to be used as a permanent dwelling or accommodation.
COMPONENTS
1
2
3
4
Fibreglass Poles
Inner Tent
Guy ropes
Flysheet
Pegs
RM
00
26
