9
Rollerdor RD20X2 Control Box, Edition 2022/1
WIRELESS KEY PAD
INSTALLATION
Fit directly to the wall using the 2 fixings making sure it is level and square with the writing at the bottom.
1
Press and hold the “RADIO PROG” button
(fig.15A)
. You will hear a beep and the red LED
alongside “C1”
(fig.15B)
will illuminate, then
release the “RADIO PROG” button.
2
Enter the access code and press OK
(fig.18B)
.
The panel will beep to confirm it has accepted
the unit.
3
Leave for several seconds and the receiver
box will beep twice to confirm end of
programming.
PROGRAMMING TO RECEIVER BOX
fig.18
PROGRAMMING CODES
Master Code:
1
Press and hold the * button
(fig.18A)
. For 3
seconds until the LED issues a slow red
flashing light.
2
Enter the master code (factory issue 12345678)
and press OK
(fig.18B)
. The red LED will
flash faster.
3
Press the * button
(fig.18A)
then enter the new
master code followed by the * button. The LED
will flash green.
4
Enter the new master code again followed by
the * button
(fig.18A)
. The LED will have
a permanent green light for 2 seconds then go
out. This means it has been programmed. If the
second entry doesn’t match the first, the LED
will flash red and it has not been programmed.
1
Press and hold the * button
(fig.18A)
for
3 seconds until the LED issues a slow red
flashing light.
2
Enter the master code and press OK
(fig.18B)
. The red LED will flash faster.
3
Enter your new access code (1 to 8 numbers
long) followed by the channel number from
1 to 4 (e.g. 5555 is the number and 1 for the
channel so 55551) and press OK
(fig.18B)
.
4
The LED will have a permanent green light
for 2 seconds then go out. This means it has
been programmed. If you wish for more than
1 access code, then it must be programmed
to a separate channel otherwise it will just
replace the already stored code.
Access Code
Pictures are for illustration purposes only, connector blocks are not provided and further fittings may be required.
A
B
