Unscrew the protective screw, put the mirror in
the slide of the upright and fix again the screw
as well as the back screw B (Picture F on page
2).
Attention: Both wires should be outside (Picture
I)
At this stage, the mirror is at its place but must
be hold.
5.Mounting of the top parts
A. Mounting of the roof
Remove the protective film from the roof and put
the roof on both uprights. (Picture J)
B. Mounting of the top shelf
Place the shelf on the roof with both plastic sha-
ped parts up. (Picture K)
Fix the screws A (Picture F on page 2).
C. Mounting of the plexiglas
Remove the protective film.
Place the plexiglas under the stainless steel roof
(Picture L) and fix the screws D (Picture F on
page 2).
Picture J
Picture I
Picture K
Picture L
10
Starting
-
Press on the switch (n°3 on picture), the machine is on. The preset electronic
thermostat flashes and displays the temperature.
- Wait until the salad’bar is at the right temperature
- Press on the second switch (n°2 on picture) to turn on light.
Temperature setting
The electronic thermostat is preset in factory at 2°C. It can be adjusted if neces-
sary.
To modify the temperature, press the "set" key for 5 seconds: the programmed
value is displayed and the LED flashes. Use the arrows to adjust your tempera-
ture. (between +2°C and +10°C).Press simultaneously on the arrows to validate
the new value. The controller returns automatically to the temperature display
screen and the LED no longer flashes.
Stopping the appliance
- Set each switch (n°2 and 3 on picture) on 0: the appliance is no longer function-
ing.
- Disconnect the power cable.
- Clean the appliance. (see 6. Cleaning)
d) Breakdown / repair:
In case of breakdown or of damaged part, please call your after-sales service and
confide any technical operation to qualified person.
When you contact the after-sales service of your distributor or your store, give him the
complete reference of your device (commercial name, type and serial number). This
information appears on the visible descriptive plate behind the device.
6. CLEANING AND MAINTENANCE
Disconnect the device.
- Clean regularly the metallic parts after each use by using only use non-abrasive
products, warm water and wash liquid: avoid the abrasive towelling. Rinse your de-
vice with a wet sponge and dry it with a soft cloth.
- Never clean the device under a water jet, the infiltrations would risk to damage it in a
irreparable way.
- Never immerse the cord or the plug in the water or quite other liquid to avoid any
electric shock.
- Never use abrasive product or vinegar; it could damage the container in irremedi-
able way
5
