13
Controls and operation
Gimbal Motors
1. Pan (Yaw) Follow: The Pan axis follows the movement. The tilt and roll axes are locked.
2. Tilt – Pan (Yaw) Ffollow: The Tilt and Pan axis follows the movement. The roll axis is locked.
3. All Lock Mode: All three axis are locked.
4. All Follow Mode: All three axis follow the movement
Joystick
1. Press once: Pan (Yaw) Follow Mode
2. Fast double-click: Tilt – Pan (Yaw) Follow Mode
3. Fast triple click: All Lock Mode
4. Fast four times click: All Follow Mode
5. When the gimbal is turned on: Press and hold the joystick, then briefly press the On/Off button
to turn off the motors. Press the joystick again briefly to restart the motors.
6. When the gimbal is turned on: Hold down the joystick and then press the On/Off button twice
briefly: Auto Tuning.
Note:
Here the gimbal calibrates the motors based on the payload and adjusts the motor
parameters.
7. When the gimbal is turned on: Hold down the joystick, then briefly press the On/Off
button three times: Inception Mode.
Note:
Then move the joystick left or right to rotate the camera.
Power buttton
1. Long press: Switch on and off the Rollei GO! DSLM.
2. Press once: Start/Stop recording.*
3. Fast double-click: Take a Photo.
4. Fast triple click: Re-Center the gimbal.
5. Fast four times click: Activates the roll motor control.
Dual Handle Setup
• Mount the two side handles and secure them with the screw 1 .
• Loosen the locking screw in the middle of the holder, then mount the double
handle in the desired position 2 .
• Tighten the screw.
2
1
1
*Only in conjunction with the
appropriate camera control cable.
Summary of Contents for GO! DSLM
Page 51: ...51 Rollei GO DSLM ...