18
This is how it works:
This is how it looks:
This is what it‘s for:
Rollei Fototechnic GmbH, Salzdahlumer Strasse 196, D-38126 Braunschweig, Tel 0531-6800-0, Fax 0531-6800-243, eMail [email protected]
19
This is how it works:
This is how it looks:
Rollei Fototechnic GmbH, Salzdahlumer Strasse 196, D-38126 Braunschweig, Tel 0531-6800-0, Fax 0531-6800-243, eMail [email protected]
:
Your camera uses four size
AA alkaline batteries of four
NiMH batteries or four
rechargeable batteries, type
NiCd.
Should you use rechargeable
batteries, make sure that
these have been fully
charged in a suitable
charger.
Always turn the camera off
before loading or exchang-
ing batteries.
Open the battery compart-
ment by pushing its cover in
the direction shown (1), then
open the flap (2).
Load the batteries in
accordance with the +/-
marks.
Loading alkaline or
rechargeable batteries
The camera should prefer-
ably be used with high-
capacity NiMH batteries.
After changing batteries,
check whether the built-in
clock is set to the correct
date and time.
If the camera is without
power supply for over five
minutes, the clock may be
slow or it may reset. In this
case, set date and time.
Left without power supply
for a prolonged period, the
camera will „forget“
individual settings and reset
to default values.
However, the pictures stored
on your memory card will
not be lost.
Do not put the camera
down with the battery
compartment open to
prevent damage to its cover.
Be careful when changing
batteries that may get hot in
use.
Checking battery power
With batteries loaded, the
camera will automatically
check their status and
display it on the LCD
monitor.
lit
Full power.
lit
Declining battery power, but
the camera is fully opera-
tional.
If the display disappears,
followed by the battery icon
blinking for five seconds and
disappearing once more,
battery power is insufficient
for camera operation.
Replace all batteries by fresh
ones, or use the optional
power-supply unit.
If the LCD monitor is blank,
replace all batteries and
make sure they are inserted
with their +/- poles properly
oriented.
If left unused for three
minutes, the camera will
automatically switch off to
save power. To resume
operation, press the power
switch.
If you wish, you may select
intervals of 1, 5, 10 or 30
minutes for automatic cutoff.
When the optional power-
supply unit is used or when
the camera is connected to a
PC, the cutoff interval is
always 30 minutes and
cannot be varied.
Power supply
Power supply
This is what it‘s for:
