Page 3.1
Easy spring WAND Installation Manual | April 2018
© Copyright 2018 | Rollease Acmeda Group
SECTION 3
− TROUBLESHOOTING
NO. PROBLEM
CAUSE
SOLUTION
1
Cannot find limit
Limit incorrectly Set
a)
Allow blind to raise fully
b)
If the bottom rail is too high and contacting the brackets, then…
i.
Wind limit adjustment wheel in the direction that would
lower the Shade *
ii.
When the Shade starts to lower this indicates the limit has
been engaged
c)
Use limit adjustment wheel to raise or lower limit as required
* Note : If limit wheel appears to require numerous turns, raise the Shade
to approximate top limit position, un-install the shade from mounting
brackets, remove the limiter from the tube, rotate and move limit nut to
appropriate stop position. Reassemble and re-install Shade to adjust top
limit. Refer to “Section 2, Part D”
2
Erratic Behaviour
Shade falls
Connector on wrong
end
Remove and re-install on other end (See Assembly Manual, Section 2,
Part C)
No Pre-Turns
Add pretensions (See Section 2, Part C)
3
Shade rises too
quickly
Wrong Decelerator
Remove and re-install correct Decelerator (See Assembly Manual, Section
2, Part B)
Too many preturns
Remove pre-turns ( See Section 2, Part C )
4
Operation of the
wand does not
lower or release
shade
Incorrect hand Control
Remove control and replace with correct hand control
Control is not fully
engaged with
Connector
Check deductions and/or bracket spacing are correct and according to the
specifications
5
Shade does not
raise
Incorrect hand Booster
Remove control and re-orientate the booster (See Assembly Manual,
Section 2, Part C)
Control is not fully
engaged with Booster
Remove control and check with booster (See Assembly Manual, Section 2,
Part B)
Not enough pre-turns
Add pretensions (See Section 2, Part C)
All manuals and user guides at all-guides.com
all-guides.com
