16
| Automate
™
Programming Instructions | Venetian Tilt Motors
ROLLEASE ACMEDA
9
SLEEP MODE
Enter Sleep Mode
Sleep mode is utilized to
prevent a motor from incorrect
configuration during other
motor setup.
Hold
P1
button on the motor
head
If multiple motors are grouped on a single channel, Sleep Mode may be used to put all but 1 motor to sleep,
allowing programming of just the one motor that remains “Awake”. See page 6 for detailed
P1
functions.
Exit Sleep Mode: Method 1
Exit sleep mode once the shade
is ready.
Press and release
P1
button on
the motor head
Exit Sleep Mode: Method 2
Remove power and then
re-power the motor.
Motor Response*
Motor Response*
12 SLEEP MODE
Approx.
ROLLEASE ACMEDA | AUSTRALIA
110 Northcorp Boulevard,
Broadmeadows VIC 3047, AUS
T +61 3 9355 0100 | F +61 3 9355 0110
ROLLEASE ACMEDA | USA
Level 7 / 750 East Main Street
Stamford, CT 06902, USA
T +1 800 552 5100 | F +1 203 964 0513
ROLLEASE ACMEDA | EUROPE
Via Conca Del Naviglio 18,
Milan (Lombardia) Italy
T +39 02 8982 7317 | F +39 02 8982 7317
G
13 TROUBLE SHOOTING
Problem
Cause
Remedy
Motor is not responding
Battery in motor is depleted
Recharge with a compatible
charger
Insufficient charging from solar
PV panel
Check connection and orientation
of PV panel
Controller battery is discharged
Replace battery
Battery is inserted incorrectly
into controller
Check battery polarity
Radio interference/shielding
Ensure transmitter is positioned
away from metal objects and
the aerial on motor or receiver
is kept straight and away from
metal
Receiver distance is too far from
transmitter
Move transmitter to a closer
position
Charging failure
Check power supply to motor is
connected and active
Motor beeps x10 when in use
Battery voltage is low
Recharge with a compatible
charger
Cannot program a single motor
(multiple motors respond)
Multiple motors are paired to the
same channel
Always reserve an individual
channel for programming
functions. Use Sleep Mode to
program individual motors.
rolleaseacmeda.com
NOTE: * ONLY THE PASSTHROUGH MOTOR BEEPS
