23
Using the GFC-50 to Operate the VGA-3
Storing (Writing) to the VGA-3’s
Memories Using the GFC-50
fig.0210
1.
Using the VGA-3’s knobs and buttons, prepare a tone
you want to store.
2.
Press the VGA-3’s [WRITE] (1) , causing the indicator
to flash.
3.
Press the GFC-50’s pedal (2) to select which of the
Banks 0–3 in which you want to write the tone.
4.
Press the GFC-50’s pedal (3) to select which of the
memory numbers 1–10 to which you want to write the
tone.
* If you want to cancel, press the VGA-3’s [MANUAL] (4).
5.
Press the VGA-3’s [WRITE] (1) once more.
During the write, the [WRITE] indicator flashes rapidly;
the write is completed when the [WRITE] indicator stops
flashing and stays off.
Control Using an External
Foot Switch or Pedal
Connecting an external foot switch or expression pedal to the
GFC-50 allows you to use your foot to control the following
VGA-3 functions.
fig.0220
When using two external expression pedals, set the EXP
PEDAL mode in the SYSTEM settings to [2] GK/WAH.
“EXP PEDAL MODE Setting” (p. 25)
GFC-50
VGA-3 panel
(3)
(2)
(1)
(4)
Set the polarity switch
as shown below.
Foot Switch
BOSS FS-5U (optional)
Switching banks (UP/DOWN)
Same function as the
VGA-3’s FOOT SW jack (FS1)
Same function as the
VGA-3’s FOOT SW jack (FS2)
Volume
Same function as the
VGA-3’s EXP PEDAL jack
Expression Pedal
EV-5 (optional)
GFC-50
Rear Panel
Summary of Contents for VGA-3
Page 34: ...34 MEMO...
Page 36: ...xxxxxxxx 00 xx xx xxx...
