7
SP-300S User's Manual
SETUP SHEET
Ink cartridge port
3. Assembling and Installing
Step 7: Fill Ink
This is different from the procedure in the “SP-300 User's Manual”. Be sure to carry out this operation by following the
procedure below.
1
When check the voltage settings are finished,
the screen shown in the figure appears.
Press the [ENTER] key.
2
The screen shown in the figure appears.
Make sure the drain bottle is installed at the
bottom of the machine, then press the [ENTER]
key.
3
The screen shown in the figure appears.
Be sure to examine the label on the ink-car-
tridge port and make sure the slot where it is to
be inserted.
4
Insert the ink cartridges.
Ink filling starts.
5
When ink filling ends, the screen shown in the
figure appears.
Sublimation ink cartridges
SELECT INK TYPE
SUBLIMATION 4C
INSERT
DRAIN BOTTLE
SET CARTRIDGE
1 2 3 4
Summary of Contents for VersaCAMM SP-300S
